Scofield chromix admixture full#

Some values have only SI units because inch-pound equivalents are not used in practice. Combining values from the two systems may result in non-conformance with the standard. The values stated in each system may not be exact equivalents therefore, each system shall be used independently of the other. When a combination of pigments is used to produce the desired color and color intensity, the total dosage rate of all pigments combined shall not exceed any of the individual maximum dosage rates of the component pigments.ДЎ.5 The values stated in either SI units or inch-pound units are to be regarded separately as standard. If more extensive information is required for a particular job, additional testing criteria and procedures should be agreed upon between the seller and user.ДЎ.4 The maximum prescribed dosage rate of a pigment, established in accordance with 4.7, shall be equal to or less than 10 mass % of cement. This specification is not intended to establish compatibility of pigments with any other concrete admixtures unless they are tested in combination in accordance with 4.7.ДЎ.2 This specification does not include the determination of pigment stability when elevated temperature using low-pressure (atmospheric) or high-pressure (autoclave) steam is used to accelerate the curing process.ДЎ.3 In addition to tests defining the pigments themselves, a limited number of tests on concrete are included to define the effects on setting times, air content, and compressive strength. Where the pigments are a constituent of a multicomponent admixture, this specification applies to the pigment constituent of the admixture. ScopeДЎ.1 This specification covers the basic requirement for colored and white pigments in powder form to be used as admixtures in concrete for the purpose of producing integrally colored concrete. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

Scofield chromix admixture full#

It is informational only and not an official part of the standard the full text of the standard itself must be referred to for its use and application. This abstract is a brief summary of the referenced standard. Cement (either Type I or Type II), aggregates, and admixtures materials shall be subjected to the following test methods: water wettability alkali resistance percentage of sulfates water solubility atmospheric curing stability light resistance effects on concrete, which include preparation of mixtures, making and curing, time of setting, air content, and compressive strength and color match of shipment. This specification does not include the determination of pigment stability when elevated temperature using low-pressure (atmospheric) or high-pressure (autoclave) steam is used to accelerate the curing process. This specification covers the basic requirement for colored and white pigments in powder form to be used as admixtures in concrete for the purpose of producing integrally colored concrete.